The mold of isolation pier has been playing an important role in the erection of overpass and the construction of expressway, and the demand for the mold of highway isolation pier is also gradually rising. The size of each mold is not fixed. Our factory can customize the mold according to the different use conditions of customers, so that the role of isolation pier can be played more. The drawing size of customized isolation pier mold is provided by customers. The design of steel mold for isolation pier is very important. Now isolation pier is often used in engineering construction and daily life. For example, isolation piers are placed around the entrance of primary schools. Usually, the height of the isolation piers is about 50 cm, and the length is less than one meter. The volume is relatively small. There are four holes with the same diameter, size and shape in the upper part of the two sides of the isolation pier. It is convenient to use the rope to connect these isolation piers together, which can better protect the safety of students and make the isolation pier play the anti-theft effect. Placed around the toll station can limit the traffic flow, so that the passing vehicles can pay in and out orderly. Thus it can be seen that the use of isolation pier is very wide, so in the production of time also according to the standard production and assembly, in order to make the use of the mold more long.
The mold of highway isolation pier can also be customized according to the different application areas. The size of isolation pier in ordinary life is smaller, and the mold size of concrete isolation pier used in highway will be correspondingly larger. Because the anti-collision situation will be significantly improved. The supply and demand of concrete isolation pier mold is very large, and the mold can be reused for a long time, which can standardize the size of isolation pier. In use, it is usually produced by prefabrication process, and then the isolation pier is uniformly installed and placed. After use, the cleaning and maintenance of the mould can not be ignored. After the mold is used, it should be disassembled first, and then the surface of the floating soil is cleaned, and then the mold of highway isolation pier is cleaned with brush or gauze dipped with detergent. The solidified concrete is cleaned and washed with water, and the water can be saved after being cleaned with cotton cloth.