The mold of isolation pier is a well-known cement component for highway interception. This kind of cement component is heavy in weight and large in size, which is difficult to carry and make. However, highway isolation pier mold is also necessary for highway. The traditional cement isolation pier is made of plastic mold, that is, mold. There are great limitations in production. The plastic texture is soft. At present, the specification of isolation pier mold produced by larger injection molding equipment is 500 * 450 * 500 small mold. Because this mold is an integral injection molding, the mechanical equipment is designed to The damage is also very large. Through long-term observation, research and a series of production tests, the production designer of the isolation pier mold has carried on the overall transformation, its characteristic is that the production raw material uses the steel plate, so the isolation pier mold can be made at will, but this puts forward higher requirements for the technical processing personnel, this steel mold material isolation pier mold processing process Seamless connection should be made between each panel in.
The production of the isolation pier mold should be smooth inside without obvious welding spot. Once the concrete is poured, a complete cement isolation pier can be obtained after the panel is disassembled. The concrete anti-collision guardrail mold belt is mostly set on both sides of the road which is easy to trigger danger, such as highway, railway, viaduct, etc The construction party shall purchase quantitative anti-collision guardrail mold and carry out construction. The template is different from the mold, in the operation process need to pay attention to the place here to explain. The mold of highway isolation pier is composed of two large panels. During the construction process, the formwork should be fixed before concrete pouring. The specific operation method is to clean the ground first, and then support the panel with iron bar. The two panels are connected with clasps. If there is a gap between the panel and the ground, wood wedge is used to fill and fix.